Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Question: finishing spalted buckeye

Posts

Question: finishing spalted buckeye

#1

Question: finishing spalted buckeye

Pat Evans

I am making some gifts from spalted buckeye and wanted the finished look to be much like the unfinished wood. However, as you can see from the pic, the piece on the left with tung oil is considerably darker than the unfinished piece on the right. I experimented with just poly, but it darkened the wood too. Is there any finish that won't darken the wood? Could I get by with just wax?


Re: Question: finishing spalted buckeye

#2

Blond shellac, about 1.5 pound cut

Bill Tindall

Re: Question: finishing spalted buckeye

#3

Finishing - Proofread

Mark Mandell - Gone Round In Jersey

Pat,

To get water-white (clear, non-darkening) finishing, you're looking for some of the new waterborne acrylic lacquers. They do have a tendency to raise grain so an alcohol or fast solvent-based sealer will eliminate a lot of sanding on the first coat. When I want as little amber as possible, I seal with a 1.5lb cut of 100% dewaxed Ultra Pale shellac, followed by a quality waterborne like Target's Em-Tech or General Finishes' Enduro. If you don't want to go the mix-your-own route on the sealer, Zinsser's Seal Coat does a good job with very little coloring. You do want to stay away from the Big Box stuff like Poly-crylic [sp] as the films have diffraction ratios that push them into the cool blue range.

Of course, you can also go through the water grain-raising and resanding routine instead of the sealer, but I find I get much better grain "pop" with at least a spitcoat of shellac.

[I really hate it when I go back and read something I posted that looks like I typed with my feet. Sheesh!]

Re: Question: finishing spalted buckeye

#4

Ellis Walentine

Here's what I use... *LINK*

Ellis Walentine

... although I can't find it on Velvit's website, so you would have to call them and see if it is still available....

Ellis


Velvit Aqua-Shield

Re: Question: finishing spalted buckeye

#5

Clint Searl

Re: Question: finishing spalted buckeye

Clint Searl

Varathane waterborne poly or clear acrylic lacquer.

Clint

Re: Question: finishing spalted buckeye

#6

Thanks

Pat Evans

Thanks for the responses. I've never used shellac before, but I'll give it a try.

Re: Question: finishing spalted buckeye

#7

Re: Question: finishing spalted buckeye

del schisler

I have made lot's of jewerly box's out of this wood. I use M.L.Campbell simi gloss lacquer and all that it did for me was make just get more yellow and not go darker. At least it worked for me. I also use this lacquer on all my box's . I also have spalted maple and it work's fine also. Sure look's good. This is a cabnet grade lacquer. Bought in 1 gallen size .