Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

BS Dust question

Posts

BS Dust question

#1

BS Dust question

John Veerkamp

I have a new Rikon 14" delux BS. The dust collection port does not suck. I'm thinking of placing a hose right under the table near the lower guides. I now have a 4" flex connected to the built in port low on the side. I'm planning on installing a Y in the line to install the second port. My question is would it be better to keep both ports at 4" or to reduce one or both in size? and if reduced to 3" or 2".

I know the collective wisdom herer can guide me.

Thanks,

John

Re: BS Dust question

#2

Re: BS Dust question

del schisler

i belive if you lower the hose's to 2" or 3" that will take away from the 4". I know if it were me i would keep all at 4". A -Y- in the line will drop the sucking power a little on both but not that bad. My thought's on dropping a line down to 2" or 3" that this size will not suck as much as you would like. My 2 cents

Re: BS Dust question

#3

JL

Re: BS Dust question

JL

I've used the band saw in question and it does have problems.

IMO - you can use a 2 1/2" and use the 2 1/2" at the lower guides. I have a similar set up on my router table. I have a 4 x 4 x 2 1/2" "Wye". I've got the 4" going to the "chamber" just beneath my router and the 2 1/2" going to the router table fence. It manages to collect all of my dust - then again, I'm running a 2 HP cyclone.