We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
The announcement from Stanley in Woodshop News said the "contractors" line was chrome/carbon steel (more rust resistant) while the bench chisels were carbon steel (arguably better steel for our needs).
Typically, well in fact every time, when I have encountered heat treating data the precision for heat treating is quoted over a "2 point" range, for example 58-60. I presume this to mean that a typical heat treating operation can control variables to ensure a hardness range of "2 points". Yet the data you got is a 4 point range.
I don't know what to make of the response you got. But I do appreciate the effort to get it.
I had exactly the same thought Bill, but since I am less of an expert than you are I thought I would wait and see if somebody mentioned it. I thought a 58 was on the soft side for chisels but a 62 would work pretty good.
Bill , you and Moses can contact Amy , her address is in the email to me.
She more then likely then will tell you the same thing, in addition she is a Customer Relations person , which means she doesn't know squat about tool Steel and the Tempering process , so she said what she was told to say by the techs at UK Stanley.
When I first inquired in plain English what was the range of Hardness on the Rockwell "C" scale she thought somehow I wanted to know if they were going to be sold in The UK.
Had to try again and tell her that was not the question, so there
you go, they will not be available in the UK , only the US.