Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Ebonizing Follow-up

Posts

Ebonizing Follow-up

#1

Ebonizing Follow-up

Mark Mandell - Gone Round In Jersey

Has anyone here tried the vacuum/pressure-treating dye process?

Seems like I could rig up a 2" pipe "chamber" fairly easily, then mix a half gallon of alcohol black dye and hook'er up to my vacuum pump to get full penetration.

Re: Ebonizing Follow-up

#2

a flaw in the ointment

Bill Tindall

If you hook a container of alcohol to your vacuum pump you will evaporate the alcohol at a furious rate.

Re: Ebonizing Follow-up

#3

Not quite

Mark Mandell - Gone Round In Jersey

You pull a hard vacuum on the chamber, seal it, then let it suck in the dye from a second port, let sit an hour, pressurize the chamber to 90psi or so, let sit an hour, lastly bleed the pressure. If you don't continuously pull the vacuum, you avoid the dye solvent (water or alcohol) "boil".

Re: Ebonizing Follow-up

#4

JL

Re: Ebonizing Follow-up

JL

"Has anyone here tried the vacuum/pressure-treating dye process?"

Personally or professionally? Yes, I did it for a couple of years in a company that I used to work for. We would draw a vacuum on the wood and hold it under vacuum for a period of time - this was to get rid of residual moisture and volatiles. We would do a nitrogen purge and hold. We would then draw a second vacuum. We would then let in the dye liquor and put pressure on the liquor tank.

I suppose you could just pressurize the vessel if your wood was beneath the surface. The process worked quite well for us. We used aluminum "boxes". I wouldn't want to use galvanized and I would be leery of using PVC.

Re: Ebonizing Follow-up

#5

Gas

Mark Mandell - Gone Round In Jersey

Figured to use Sch. 40 ABS (black) for the "wet"/pressure chamber.

A bit short on nitrogen here. Since I'm working with dry wood, I'm thinking the volatiles are mostly gone already.

What was the purge for?

Re: Ebonizing Follow-up

#6

JL

Re: Gas

JL

We were working with some reactive chemicals to "lock" the dye into the wood fibers. We needed a nitrogen purge after the initial vacuum to insure that the water was completely gone.

As you aren't working with reactive chemicals, you won't probably need a nitrogen purge. I would leave it under a vacuum for a period of time though. It couldn't hurt.

Re: Ebonizing Follow-up

#7

reason for nitrogen-oxygen purge

Bill Tindall

My bet is that its purpose is to purge oxygen from the system before introduction of the flammable liquid. An industrial process is not going to want a mixture of flammable vapors and oxygen in a container if it can be avoided.