WE MOVED...
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

No or Slow drying finish

Posts

No or Slow drying finish

#1

No or Slow drying finish

Lynn Baker

I've coated a previously factory finished utility cabinet with wipe-on poly after light sanding and staining and the finish is remaining tacky after two days at 70+ degrees indoors and ample ventilation.

If you have suggestions or ideas to either make the finish dry or redo the effort, they would be appreciated.

Thanks

Lynn

Re: No or Slow drying finish

#2

Re: No or Slow drying finish

Bill Tindall

sorry, no experience with the finish you are using. Customer service for some companies can be helpful. I tried a two part epoxy finish I had never used before and it "clotted" immediately upon mixing the two components. I called customer service, was quizzed with reasonable questions and they declared something defective in the material. They sent me a new batch. It's worth a try.

Re: No or Slow drying finish

#3

Re: No or Slow drying finish

del schisler

You don't want to put poly over lacquer or lacquer over poly. The two are not compatible with each other as you will have adhesion problems if you try it. Also if you didn't sand down to the wood and stained . The stain probly didn't have a place to go. And did you wait i belive 8 hrs Before you put poly on or over nite. That is what i do but i use stain on bare wood only and wait over nite? I use cabnet grade lacquer only for my item's. You may have to strip unit's down and start over ??

Re: No or Slow drying finish

#4

Re: No or Slow drying finish

Lee Schierer McKean, PA

I've had this happen once or twice. The cure I used was to sit the piece outside in the sun for a couple of days on good warm sunny days exposing the various areas where finish was applied to direct sun heat.

Lee

Re: No or Slow drying finish

#5

Re: No or Slow drying finish

Steve Schoene

Poly over dry NC lacquer won't have a compatibility problem that would cause the poly not to dry. The other way around can cause problems because the strong solvents in the lacquer can attack the poly.