Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Flattening Table top question

Posts

Flattening Table top question

#1

Flattening Table top question

Barry Irby

My son bought a 16" wide Cherry board form a guy with a bandsaw mill. The board was a little under two inches thick and six feet long. He had the guy resw it into a book matched pair. They are about 3/4" thick. They warp in about every direction they could. We are trying t make a table top out of them. Sort of like wrestling with an Anaconda. I think we have gotten them to the point we can attach them to a sturdy frame and pull them flat. My question is; Would it be wise to route some kerfs the length of the boards on the under side?

Re: Flattening Table top question

#2

not necessary

bill tindall

What is critical is to have gotten a good glue joint that will temporarily hold some stress. Then slowly pull the top flat against the frame. Spend a month or so doing it if the lack of flatness is extreme. To recall a recent discussion, the wood will creep into submission over time. On the other hand, if you can mash the top flat with moderate hand or butt pressure, just fasten it to the frame and forget it.

I once pulled nearly 2" of bow out of a top once.

Re: Flattening Table top question

#3

Re: not necessary

Marv

Bill,

How bout using steam?

Re: Flattening Table top question

#4

not in this case

bill tindall

Recall some time ago I posted about taking the bow out of a piece of mahogany......before I book matched it into an unsupported panel. As I understood, the table top is already glued up. If not, by all means try to steam out some of the twists and turns.

Re: Flattening Table top question

#5

Clint Searl

Re: Flattening Table top question

Clint Searl

I'm about to start a base for a cherry flitch table top of about the dimensions of your glue-up. It both cups about 1/4" across the width and twists so that the legs will vary in height by 1/2" from the shortest to the tallest. The top has been in use and the variation makes no noticeable difference, so I'm making the base to accommodate it rather than trying to change its personality.

Heroic attempts to flatten your work is unlikely to be successful, so consider the alternative. If your prize mule's ears keep hitting the top of the barn door, don't shorten his ears, just trench out the sill.

Clint

Re: Flattening Table top question

#6

Re: Flattening Table top question

FredD

>;-))