Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

leveling shellac

Posts

leveling shellac

#1

leveling shellac

barry

I applied about 12 coats of shellac to a box top (open pore mahogany; should have filled the pores), waited about 3 days and am starting to use 800 grit sandpaper with water to level it all out. It sure is a lot of work. Any comments on how to make this job easier/quicker? Also, I'm leaving slight fingerprints on the lid. Maybe I should have waited a few more days. Could use your thoughts/comments on that also.

How about 0000 steel wool w/oil at any point?

Re: leveling shellac

#2

Re: leveling shellac

Dick Coers

I would start with something like 400 grit with mineral spirits as the lube. Then work up to the grit you want for the gloss level you want. If you're getting fingerprints, set it off to the side for a couple weeks. There is definitely a difference between dry and cured. Humidity is also a big variable. Just let it sit for a while.

Re: leveling shellac

#3

Re: leveling shellac

Bill Tindall

Any comments on how to make this job easier/quicker?.........400 grit

Re: leveling shellac

#4

Re: leveling shellac

FredD

Way to much Shellac , since you went that way ,get on it with a freshly burred Card Scraper , then dry sand with 220 Garnet , recoat one mrre time if the finish is not slick enough , rub it out with Mequiars compunds , available at any Auto parst store.

Shellac is not the best finish for sanding to start with and that many coats would take a considerable time to harden enough for optimable sanding.

FredD

Re: leveling shellac

#5

Re: leveling shellac

Kelby

Fingerprints = not cured. Let it rest.

I've had good luck with steel wool on cured shellac.