I like mine...
Grant in Iowa
Hi Barry,
I used to use a DeWalt lunchbox planer and my method of work was run a stack of lumber through, measure one board with a caliper, and repeat to sneak up on my desired dimension.
About five years ago, I found a Delta DC-380 planer for a reasonable price and decided to buy it. I work almost entirely with roughsawn lumber, and I was worried about the longterm durability of the DeWalt in such an evironment, so it made sense to get a larger planer.
I found out almost immediately that the larger planers such as my Delta DC-380 and its clones: Jet, powermatic, and General international all share a common design of using a serrated infeed roller. This roller leaves infeed roller marks on the wood unless you remove at least 1/64"-1/32" or so on the final pass. So you can't plane/measure/plane to remove the last tiny amount in order to hit the thickness dimension you need. You must measure or know the desired dimension, and hit the mark exactly the first time. Frustrated, I would bring the boards to rough dimensions with the larger planer, then go to my DeWalt for the final few passes with caliper in hand to land on the exact dimension I wanted. Down side to this was that I wanted to recapture the capital from the lunchbox planer by selling it, but I needed it to do final thicknessing accurately. Having two planers was also taking up too much space.
I bought the Wixey planer thickness guage and installed it on the DC-380 as shown below. 
The first year or so it ate 3 batteries, mostly because I would forget to turn it off after use. I discovered that Wixey had updated the readout design to include an auto-off feature and called them up to inquire about upgrading mine. To my delight, they agreed to send me the updated head for the cost of shipping. I installed that and have been extremely happy ever since. I don't think I have changed the battery in 2-3 years.
It might take a bit of ingenuity to get it installed on your machine, but I didn't find the process too bad. Once you play with the unit a little while, you see what you need to do and it is fairly straight forward to solve the mounting problem.
Once installed on you machine, you run a board through the planer and then place that board between the measuring bar and base and press "calibrate" on the readout and it is set to measure thickness correctly on your machine. From then on, you just run your batch of boards through until you are close and set the machine to the final thickness dimension. No test passes or measuring or getting out the caliper to use the planer. Once calibrated, the readout stays calibrated until the battery dies, or until you bump it hard enough to throw it off. The unit even knows where it is if you crank the planer head while it is turned off, so you needn't recalibrate very often.
I find it is also nice to be able to go back later and hit the exact same thickness for another part. For example, If I am making up a panel and don't like the grain in a given piece, it is no big deal now to make another board exactly the same thickness.
The readout reads to the nearest .005" , which is close enough for woodworking.
As a former machinist, I much appreciate the ability to get a desired thickness without futzing around. It saves time, passes through the planer, and having the calipers laying around.
And I was able to sell the Dewalt lunchbox planer after all.
Regards,
Grant in Iowa