Performax switch went bad again....
Barry Irby
I bought a 16/32 Performax used. Sometime alter the switch got glitchy and finally stopped working. I ordered a new one. Had one of those cute little paddles on it with the piece you can remove to prevent anyone using the tool. I installed it and life was good. Took the old switch apart just to see what was wrong and it was FULL of sawdust. Nothing actually wrong, just so pact with crud it could not work.I tried to put it back together, but apparently I did not have the proper training and skill set and uncharacteristically gave up and threw it away. Took several days for the Pack Rat Gene in me to let the guilt go.
Last night, I pulled out the Performax and NOTHING. Checked the plug, it was live. No juice going through the switch. This one did not glitch out, it just quit. I was using the machine the day before, and then nothing. The switch is several years old. Took it out and took it apart and there was a small amount of crud in it and the contacts were slightly pitted. There were two littler rockers that actually make and break the circuit. Polished the contacts on them with 1500 sand paper. Chucked a pencil in a drill and polished the contacts in the switch body (could not get at them with sand paper.) Blew it out and put it back together and it works. Pretty happy about that.
But, The first switch was a toggle switch and the toggle was looking straight up, basically a funnel for sawdust. The second switch was sealed better and I think the paddle serve to keep some of the sawdust out. It still seems to me to be a location for a better sealed switch. I have had one or two other switches fail but only after long had use and none from getting filled with sawdust.
Is there some sort of contact lubricant I should have put in the switch? Would it have attracted more crud? Wonder if I should find some sort of cover for the switch?



