Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Spraying Varathane

Posts

Spraying Varathane

#1

Spraying Varathane

Dave LaPine

Got some birch plywood covered speaker boxes and am wanting to spray some oil based Varathane on them with a HVLP gun. Would mineral spirits be the best to thin it with? We don't want to extend the drying time too much.

Re: Spraying Varathane

#2

Re: Spraying Varathane

Bill Tindall

I spray varnish. When I have it I thin with naptha as it evaporates faster, but mineral spirits will work ok, especially if it is hot. For my gun I thin about 1 part solvent to 3 of varnish. The first coat could be thinned a bit more. Spray 1 st coat, wait a day, lightly sand to remove fuzz, and spray a second. On a hot day it will be dust free in 2 hours and dry to touch in 4 or less. May take a week to fully harden.

Be careful of runs as the viscosity does not quickly build like with lacquer.

Re: Spraying Varathane

#3

Re: Spraying Varathane

Dave LaPine

Will that work ok over Varanthane that has already been brushed on the surface or will it have to be completely sanded off first?

Re: Spraying Varathane

#4

I actually called Varathane . . .

steve mackay

once upon a time and asked the very same question. Once I got past the idiot that answers phones I got someone "in the back". He said they had no procedures for spraying and that it wasn't advisable and would gum up a gun something awfull . The spray cans they sell are a different reciepe than the cans. But things change.

Re: Spraying Varathane

#5

Re: Spraying Varathane

Nicholas Tuzzolino

As long as you sand it enough to get a "bite", there should be no problem.

Re: Spraying Varathane

#6

of course

Bill Tindall

If the brushed coat is rough, sand it smooth. Use stearated paper or if the coat has sealed the wood well you can use wet/dry paper and water as a lubricant. If you use 320 grit or finer the scratches won't be visible in the 2nd coat.

Re: Spraying Varathane

#7

Re: I actually called Varathane . . .

Dave LaPine

Well we went ahead and thinned with 1/4 mineral spirits and sprayed anyway. I guess we were able to cheat a little by doing it in a downdraft booth the we heated to 90 degrees. Turned out OK. The gun even survived.