Questions on inlaying into walnut panels
Barry Irby
I have been posting about building a walnut bed for my son and DIL. Its nearly finished. Now he has hit upon the idea of inlaying a sun burst into it. We have a head board that is a walnut panel 46" tall and 10' 8" wide. It's actually in three panels. The center panel is 80" wide and the two extensions or wings are 24". It bolts up into a single large panel.
Now he wants to put a segment of a sun in the upper right corner and rays emanating from it. Also wants this on the foot board and drawer fronts.
How would you do that? I can figure out how to to cut a tapered slot for the rays, and I can cut the rays, but I have little or no experience. The ones that run roughly parallel to the grain of the walnut seem OK, but what to you do with the ones that run cross grain? So you cut the grain of the insert to be cross grain also? How thick would you make the inlay?
Any insights would be welcome.



