Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Padding Bar Clamps Question?

Posts

Padding Bar Clamps Question?

#1

Padding Bar Clamps Question?

Barry Irby

I have a bunch of pipe clamps. They are of different ages and types. Some of them have a "foot" that holds them up high enough to turn the handle and some don't. I have a bunch of scraps of 1/2" Baltic birch plywood. I was thinking of making pads for the jaws of the cramps. What I was thinking was to make pieces about five inches square with a hole in the center big enough for the pipe to pass through loosely. The Idea is that no matter which way the plywood is oriented, it will be symmetrical and hold the pipes up a given distance off the deck and all the clamps would be the same and level Etc. The jaws would be padded. Now to figure out how to keep the glue from sticking to them.

I doubt this is an original idea. Anybody done something similar? Does it work for you? Does this seem like a good idea?

Re: Padding Bar Clamps Question?

#2

Re: Padding Bar Clamps Question?

Charles Yawn

Wood magazine had a suggestion in their "Best Workshop Jigs and Organizers" titled "Stay-Put Pipe Clamp Pads". I have the page with pictures and plans and can send it to you if you cannot find the page on their website.

Charles

Re: Padding Bar Clamps Question?

#3

Re: Padding Bar Clamps Question?

Jesse Cloud

Clear packing tape on the plywood will protect the pads from glue. I use it on my bending forms and they get lots of squeeze out.

Re: Padding Bar Clamps Question?

#4

Thanks, Found it, .....

Barry Irby

Something of a struggle. Finally looked at all the "$2" plans. It was about 175 out of 178. OTOH, I saw several other good ideas. Thanks again.

Re: Padding Bar Clamps Question?

#5

Re: Padding Bar Clamps Question?

Barry Irby

I was thinking about packing tape, I have some. Wonder if it will hold up to the abuse clamps get? Easy to replace though.

Re: Padding Bar Clamps Question?

#6

Mine Work Well

George Colonel's Workshop-Havertown PA

Good Morning Barry,

I've padded my jaws on all of my pipe and I beam clamps. I think taping them to the metal jaw is the way to go, since the epoxy I used fails now and then, and is a PITA to remove and reapply. Pads DO protect work edges, making glue ups a little quicker and less critical. Furtherm, the pads seem to secure the clamps a bit better in their vertical wall rack because they are not as prone to slip as a metal surface. I hate it when a clamp jumps off the wall rack and hits me in the head. ;)

George