Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

reading your boards-how to tell curly

Posts

reading your boards-how to tell curly

#1

reading your boards-how to tell curly

bill tindall


While it is obvious when finished lumber is curly it is increasingly more difficult to determine this state as one moves back in processing toward the tree from whence the lumber came.. If there is a way to know if a tree contains curly lumber I don't know how to do it. I cut a huge maple once and didn't realize its figure until it was notched for felling.

There is a tell tale sign that a board is curly that can be detected even if the board is stacked in a pile , so long as its edge is visible. Saw mill saws are rip saws with chisel teeth just like a rip blade for a table saw. They are designed to chisel their way through the end grain of a log. When sawing a curly log these teeth encounter grain at orientations other than perpendicular to the chisel tooth. Unlike a cross cut saw these teeth are not designed to slice through the wet wood grain, and as a result they tear the grain instead of slicing it. The result is a fuzzy looking cut.

The bottom board in the picture shows a typical cut. One can see the cut made by each tooth as it passed through the log. While overall the cut is rough from irregularities among the teeth, each tooth is individually leaving a relatively smooth cut. In contrast, the fuzzy surface on the top board is the result of a cut through a curly log. The fuzz is torn grain ripped out of the log by the rip teeth in places where the grain was not oriented along the length of the log. .

So, If you are looking for curly lumber in a lumber stack, seek out fuzzy surfaced lumber.

Re: reading your boards-how to tell curly

#2

Re: reading your boards-how to tell curly

Hank Knight

Another clue is the wavy edge grain pattern visible on the top board. Everywhere the top of the wave breaks the surface on the board's face, the grain direction changes. This direction change results in curly figure.

Re: reading your boards-how to tell curly

#3

great tip.  Thanks.

Joe Pack

Re: reading your boards-how to tell curly

#4

Re: reading your boards-how to tell curly

Chuck Kettler--Greenwood, IN

Bill, your explanation sounds very logical. Is this a foolproof way to pull out boards for a closer look and has never failed you or is it more of an observation that you have made over the years and now proven?

Re: reading your boards-how to tell curly

#5

answers

bill tindall

Is this a foolproof way to pull out boards for a closer look........It is a way to screen for a closer look, probably not fool proof. While torn grain is a good indication of figure, lack of it for one reason or another is no guarantee the lumber won't be figured.

and has never failed you.........I don't spend any time looking for curly lumber so I have not given it an opportunity to fail me. or is it more of an observation that you have made over the years..........yes, and now proven........not proven, just an observation.

When we were in the lumber business I planed thousands of bdft of lumber. If it was fuzzy in the rough it was typically figured and hence difficult to plane.

Re: reading your boards-how to tell curly

#6

Re: answers

jmccull

Years ago, an old timer showed me that you can see horizontal bars in m aple while it is still on the stump. There may be no lines, a few lines or they may be quite frequent. I cant prove it is always true, but it has helped me on several occasions and seems to hold true.

Re: reading your boards-how to tell curly

#7

Re: reading your boards-how to tell curly

charlie belden

Great observation and your explanation of why fuzzy MAY indicate figured rough sawn makes a lot of sense. Bringing along a block plane and using it - with permission or course - can improve the indicator info as well.

Thanks for the tip.