Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

New Application for Biscuit cutter?

Posts

New Application for Biscuit cutter?

#1

New Application for Biscuit cutter?

Barry Irby

I was just thinking about my plate jointer or biscuit cutter. It occurred to me that you might be able to clamp a fixture on the fence and use it to cut the slots for splines in the corners of boxes. I am visualizing a v shaped gadget with a ninety degree inside corner to allow you to hold the jointer straight across the corner. Then you could make splines to fit the slots. This would be the showy kind. Anybody tried this or anything similar? Sound like it might work?

Re: New Application for Biscuit cutter?

#2

I think I've heard of that...

John in NM

Though maybe not on box corners, I remember seeing the suggestion that it could be used for cutting spline slots. Only trouble with what you suggest is that the biscuit cutter blades tend to be ATB when you need a square cut blade.

Dare I suggest another use? Model boat anchor! :D

Re: New Application for Biscuit cutter?

#3

Re: New Application for Biscuit cutter?

Dick Coers

I have a blanket chest in the living room that I did that way. I found a pretty nice piece of maple plywood once, and made the blanket chest just like a miter folded box. Cut miters on the plywood, taped along the corners, then glued and folded it up. When it had dried, I made just the fixture you are talking about. I put the walnut splines in groups of 3. I started 3/4" down from the top and bottom, then added another group of 3 in the middle. The biggest trouble I had was chip out. The blade is not made for clean cutting. I added tape on the plywood to support the veneer, and cut really slowly. I built that about 18 years ago, with no trouble. It is used as our coffee table.

Re: New Application for Biscuit cutter?

#4

Jim DeLaney, Austintown, Ohio

Re: New Application for Biscuit cutter?

Jim DeLaney, Austintown, Ohio

I vaguely remember - from back in the late 70s/early 80s, when biscuit joiner were fairly new to the U.S., that one Euro brand was advertised as having a blade that locked in place for cutting slots.

Can't remember the brand name, though. I think it started with "V".

Re: New Application for Biscuit cutter?

#5

Re: New Application for Biscuit cutter?

Richard McComas

You need to find one of these. It's a Delta Stationary Biscuit Cutter. I modified it so it's air operated. Now I wish Festool would make the same thing for cutting domino slots.


img

Re: New Application for Biscuit cutter?

#6

Re: New Application for Biscuit cutter?

Jim Abplanalp

Here is something similar I just finished yesterday

Iwill be using it for sliding dove tails - when the fence is removed it will remain e set up for the cross cut.

Re: New Application for Biscuit cutter?

#7

Re: New Application for Biscuit cutter?

Craig Daymon

I know it's been done before. I'm pretty sure it's even described in the manual for my DeWalt as a use. Go for it.