We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
Yesterday I had to take off the box I made to enclose my TS motor to diagnose an electrical problem.
I would rather not put it back on because it was such a pain. But I still want to enclose it "relatively" well for dust collection that is already coming in down below, not in the shroud I made. Because the motor moves with blade up & down & tilting it is a challenge. What creative ways out there have folks tried.
I was thinking brushes, leather, thin plastic with some slits cut in it like a comb...?
I take it you are working with a contractors saw. The motor hangs out the back and swings with the blade?
As you have discovered, dust collection is a problem on these saws. I have one and my approach was to make a box or rectangular tube that is bolted to the trunnions and comes up around the blade. It is angled and hinged so that the saw can swing through the full forty five degree arc. I also have the dust coming tot he front so that the blast gate is on the front of the saw so when I reach down I can open the gate, turning on the DC and turn on the saw. This was a real head scratcher to build, but it works well.
I tried to find some of the long brushes they use on tractor trailer trailers as sort of "hula skirts" around the tires. Before I got the idea for the duct/tube I used I had the idea for closing off the back with the brushes. The problem with a contractor saw is that it is so open to start with. It seems to me there are two approaches you can take. Sort of micro and macro. I went micro, trying to wrap up the blade and catch the dust right there. Macro might be to enclose the entire saw. If I were doing it again, I might eliminate the open stand and build a box for the saw to sit on and then build an enclosure to cover the motor on the back of the saw. The base could include a drawer or two for saw accessories and the rear enclosure could include an out feed table. Use the effort to solve a bunch of problems. Someone here posted a picture of their saw that had these features and my thought was I wished I had seen that first. Maybe they will post it again.
I'm sorry it is not a contractors saw. It's a general 10" & the motor comes out on the right side. That's where my original box was & why it was hard to open up the motor for the diagnostic.