Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Revisiting a Blond Shellac finish

Posts

Revisiting a Blond Shellac finish

#1

Revisiting a Blond Shellac finish

David Lykins - guitardude - Dallas GA

I met Robert Benedetto probably the world formost archtop guitar builder, a few years ago (long story) and he indicated that if you've never done a sprayed shellac finish on a guitar you should give it a shot. So anyway, I started this guitar project, essentially a fancy stratocaster lacewood top, maple back and a strip of Paduk in the center. Well I had several perfect coats of shellac sprayed on it and when I went to spray the last coat the back fisheyed and the front got a zillion tiny pits in it. Its been sitting in my shop for a couple of years now in that state.

So now that I'm still unemployed (over a year now) I decided to revisit the guitar and I started sanding off the shellac. Therefore, my questions is; Do I have to sand off ALL the shellac down to the wood or can I leave the good shellaced sections alone and will the new shellac burn in and match the old shellac? I'm using dewaxed "blond" shellac flacks.

Any information is greatly appreciated.

Thanks!

Re: Revisiting a Blond Shellac finish

#2

Re: Revisiting a Blond Shellac finish

Steve Schoene

The first thing is to find out what caused the fisheye and other problems in the first place. Usually I would expect a contaminant, either on the surface or in the shellac. Once you solve that issue, then shellac will burn into other shellac becoming essentilly one layer. Have you had other problems with that sprat gun?

Re: Revisiting a Blond Shellac finish

#3

Re: Revisiting a Blond Shellac finish

FredD

If you have Fisheye , then you have somehow got Silicone contamination.

I would sand down enough that the Fisheye no longer is visible , then mix Fisheye remover into your Shellac, which is just more Silicone and respray.

Should do the trick and you will need to thoroughly clean your cup and gun , so that doesn't happen again.

Look around your shop and see if any wax you have used contains Silicone, you can have it on your machine tops for instance and never know until you apply the finish .

FredD

Re: Revisiting a Blond Shellac finish

#4

Re: Revisiting a Blond Shellac finish

Bill White

David, why not just take some alcohol and wash off the old shellac. Start over? Isn't shellac a little soft for a solid body?

Bill

Re: Revisiting a Blond Shellac finish

#5

Re: Revisiting a Blond Shellac finish

Howard Acheson

>>>> Isn't shellac a little soft for a solid body?

Actually shellac is a very hard finish. It's similar to lacquer in that regard. However, shellac can be softened by constant contact with hands and the oils that they contain. That will cause the shellac to soften over a period of time.

Re: Revisiting a Blond Shellac finish

#6

Re: Revisiting a Blond Shellac finish

Howard Acheson

Building too thick a film of shellac can be problematic. Shellac wants to be a thin film or it can end up with surface imperfections.

Also, there are a number of contaminates that can cause fish eyes including the environment in which the shellac is applied.