Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Bosch Router Update

Posts

Bosch Router Update

#1

Bosch Router Update

Tony - Memphis

I toko my 1617 kit to the local service center as designated by the Bosch rep via email. It was tough logisitcally since they are across town from my office and work similar hours. All they do is ship it to the repair center. Turn around time was only a few days. They put a new case on the motor (Al), but didn't do anything to either base. So, on one hand, I'm impressed with the speed and ease and that they repaired an 8 year old router. On the other hand, the plunge base is cracked because it was sticking when I tried to remove it and I dropped it on the floor with the edge guide in it. The base is a very poor design structurally (I can say that - I'm an ME). Where the guide rods are suported is very very thin. I'm going to try and rig it with some JB Weld and perhaps a half pipe structure type arrangment to hold the rods and spread the force out. The replacement base is $125 and the casting itelf is around $60, so neither is a cheap option. I thought that the plunge rods had been damaged, but they seem to be ok. I've always like this router a lot. Good to know that Bosch stands behind their products. If I can't get this base rigged and working, I'll just buy a replacement part (not the whole thing) I guess. I'll make sure the plunge parts are ok for sure though. I also thought if I have to buy the whole base, why not just buy another kit and have a spare? A lot of what I use this router for is with the MicroFence edge guide (nice product and they are very customer service oriented as well).

On a side note, my Hitachi M12 has been slung, dropped, kicked, and abused in many ways and has never missed a beat. Another good router. I did have to tighten the collet once and their tech people were very helpful with that. It resides in the table now and doesn't get quite the abuse it used to get. I guess that one is at least ten years old.

Tony

Re: Bosch Router Update

#2

Re: Bosch Router Update

George Colonel's Workshop-Havertown PA

Good Afternoon Tony,

I followed your initial thread with interest. I am glad the factory service people replaced the motor housing with aluminum. Its expensive to replace the cracked base, but that is what I would do: still well under the cost of a whole new system, yet substantially upgraded.

FWIW, my aluminum P+C bases sometimes become tough to rotate around the steel motor housings of my three 690 motors. Cleaning with naptha, and buffing with wax and 4/0 steel wool seems to lubricate all the scratched surface areas to make settings smooth and easy. I do it periodically, as needed.

George