Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Watco wipe on poly-not drying

Posts

Watco wipe on poly-not drying

#1

Watco wipe on poly-not drying

Stephen Kirk

Yesterday, I wiped on a coat of Watco wipe on poly on a red oak bench already finished with 2 coats of dewaxed garnet shellac (love the color). Can states a 4 hour dry time before the second coat, however after 24 hours the boards were still slightly tacky, not enough to leave prints, just a bit sticky. I put them outside in the eastern PA oven today and that seems to be helping.

Anyone else have problems like this? Is using the nice hot sun a good idea, or am I causing other problems. I've had to do this with stain before. It's very humid right now, and that really seems to slow down a finish's drying time.

Oddly enough, the pieces felt good this morning, then got sticky as they warmed up, but now out in the sun the stickiness is going away.

Re: Watco wipe on poly-not drying

#2

Re: Watco wipe on poly-not drying

bob davis

i had a similar problem with minwax wipe on poly. wrote minwax.the told me humidity is the problem. i agree as th piece was in high humidity area. had no problem since

Re: Watco wipe on poly-not drying

#3

Re: Watco wipe on poly-not drying

Glenn Madsen near San Francisco

That makes sense, since poly technically cures and links, rather than 'dries'. Humidity would influence that.

Patience, grasshopper.

Re: Watco wipe on poly-not drying

#4

Re: Watco wipe on poly-not drying

Howard Acheson

The drying time on the label is based on 70 degrees and 50% relative humidity. Applying oil based finishes at temperatures and relative humidity above 80 degrees or 80% RH can be problematic. At the very least, flash off and drying will be extended.

One thing you can do is set a fan to keep the air moving over the finished surfaces. Sometimes though, even this will not promote full cure in very high humidity situations.