Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Finishing Question

Posts

Finishing Question

#1

Finishing Question

Jerry Draper

Is there any way to warm up the color of hard maple without dyeing or staining? I always get blotching whenever I stain or dye maple.

Re: Finishing Question

#2

Re: Finishing Question

George Colonel's Workshop-Havertown PA

Good Afternoon Jerry,

Try top coats of oil based poly, which will impart an amber glow.

George

Re: Finishing Question

#3

Re: Thanks George, I'll try it.

Jerry Draper

Re: Finishing Question

#4

blotch control Go Here utube video *LINK*

del schisler

Watch the utube viedeo on blotch control by charles neil. This will show you how to control BLOTCH on your wood. The best. also more video's

http://www.youtube.com/profile?user=InTheWorkshop#p/u/4/IfCYMdrP8rM


http://www.youtube.com/profile?user=InTheWorkshop#p/u/4/IfCYMdrP8rM

Re: Finishing Question

#5

(Message Deleted by Poster)

Chuck Lenz

Re: Finishing Question

#6

Re: Finishing Question

Barry Irby

You might try a seal coat of shellac. Use Zinsser Seal Coat. Its completely dewaxed and you can put urethane or almost any other finish over it. Also, if you want to get into it you can buy shellac in various shades up to garnet and as long as its dewaxed you can apply whatever over it.

Re: Finishing Question

#7

JL

I prefer using dye on maple

JL

both hard and soft. I can warm up the color pretty nicely with that.

Re: Finishing Question

#8

Amen to that.....

bill tindall

But, I watched someone stain maple a lovely honey color using water soluble dye and a spray gun. Should the need ever arise, that is what I will try.

And then there is birch!

Re: Finishing Question

#9

Re: Finishing Question

Steve Schoene

There are a variety of color shades available in shellac that can also warm maple, but which are more color stable over time.

Re: Finishing Question

#10

Ellis Walentine

What finish will you be using?

Ellis Walentine

Maple is a strange wood in that oils and varnishes tend to lead to yellowing over time, which is not my favorite look. Water-white lacquers and waterborne finishes tend to preserve the tannish pink color of freshly worked maple. If you want an amber glow, I'd suggest either an amber varnish like Waterlox or some dye stain under your preferred topcoat. On figured maple, some finishers like to stain with a deeper stain, on the brown spectrum, then sand the highlights, leaving color in the end/figured grain to make the effect more striking, regardless of the color or tone of the topcoat or subsequent coats of dye.

Ellis

Re: Finishing Question

#11

Thanks

Jerry Draper

Lots of good info. Thanks to all. I am going to experiment with everything that has been suggested.

Re: Finishing Question

#12

Re: Finishing Question

John Pappas

Jerry, one thing not mentioned would be the use of a glaze, which is a thin coat of color applied between coats of finish. There are specially formulated glazes for this purpose, but a gel stain can be used. Also, glazes can be made by mixing amounts of linseed oil, varnish, and artist colors or universal colors.

This is a good way to add a bit of color to pine, cherry, and maple. Especially nice with pine because it avoids the color reversal (what was light becomes dark...what was darker becomes the lighter color) that occurs when pine is stained.