End grain cutting board-major oops!
doug f, san clemente, ca
I've been making end grain boards for almost 10 years and I've never had one that did this. I'm kind of at a loss; the board is only a year old, it's well cared for (my son) and not used extensively. It's on rubber feet and there doesn't apprear to be water accumulation. The finish is one I always use, two flood coats of Waterlox allowed to soak in, then wiped off.

The crack

The "bulge"

The warp
It appears that one piece of maple has swelled considerably and warped the end section of the board, cracking the joint.
I know the fix, I just can't figure out the cause.
Insights?
Doug



