Re: Looking for plans for "plastic" Adirondack cha
Dave Paine

I do not have plans, but I can share some pictures of what I call an Adirondack inspired porch chair. True Adirondack low slung angle is hard for me to get out if my back is hurting.
I combined the shapes of two plastic chairs to make this one. I wanted some lumber support so did the vertical curved back instead of flat slats of normal Adirondack chairs.
I do not know much weight a Trex based chair could take, but considering my inspiration was plastic chairs which were perhaps 3/16in thick a Trex 1in think board ought to work.
I have part of a deck covered in the Lowe's Choicedek. So far holding up.
I made a cover for my septic with Trex. This has bowed over time.