Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

OT - Water Filter Case Stuck

Posts

OT - Water Filter Case Stuck

#1

OT - Water Filter Case Stuck

BradPA

It's time to change the filter and our house water filter case (in the basement next to the well line) is stuck. I tried to loosen it with the plastic wrench type tool with the handle that is designed to unscrew the case. I also tried whacking it with a soft blow mallet. We have been in our house for five years, I change the filter quarterly and I have never had this problem. Any ideas?

Re: OT - Water Filter Case Stuck

#2

Re: OT - Water Filter Case Stuck

Mark Mandell - Gone Round In Jersey

Shut off your inlet valve to the house from the well.

Relieve the pressure in the pipes and use the bleed valve on the filter as well. "Sometimes" the back pressure will hold them quite tight.

Instead of the soft-blow, use a piece of 2x4. The higher frequency of the vibrations from a strike from the wood will be more effective. Be careful to strike so that the force stays level and at 90� the the case's long dimension, but don't swing like you're going for the cheap seats.

When you get it off, inspect your threads and O-ring. If they are OK, wipe them with a bit of Vasolene and only spin the case back on 'hand-tight.' DO NOT use the wrench to tighten the case. The O-ring and hand-tightening is just fine to get a good seal.

Re: OT - Water Filter Case Stuck

#3

Jesper, Denmark

Re: What he said, plus.....

Jesper, Denmark

I used to have that problem. The filter casing was son�me sort of ribbed plastic. I mad a wrench to fit the case from hardwood, which solved the problem.

Re: OT - Water Filter Case Stuck

#4

Re: OT - Water Filter Case Stuck

Galen Vetterick

The pressure must be off the units as has been noted. Mine had a shutoff that takes the pressure off from both directions and a big button on the top for bleeding off pressure. Anything at all on the threads just digs in the soft acrylic like a lock washer. Units can be cross threaded and still seal.

I had to use two oil filter wrenches once to have more leverage and keep the force even on the filter housing.

You have to say the right words as well!

Re: OT - Water Filter Case Stuck

#5

Re: OT - Water Filter Case Stuck

John E in SC

I use the supplied "wrench" in 1 hand, and a band-type oil filter wrench in the other. You can get pretty good even leverage using a handle on each side. Just be careful, I did crack a housing once, and had to replace it. For that reason, I never try to change mine at night when the stores are closed! (I also learned the hard way that the pressure has to be bled off before that thing will even THINK about turning!) I use plumber's silicone on the O-ring when reinstalling, which seems to help a lot.