(Message Deleted by Poster)
Chuck Lenz
Knowledge You Can Build On — Est. 1998
(Message Deleted by Poster)
Chuck Lenz
(Message Deleted by Poster)
Chuck Lenz
Re: Ryobi AP12 Surface Planer Dust Hood with 4" po
Barry Irby
Looks good to me. My only suggestion would have been to make the dust hose come off the same side as the cord. On my Dewalt, the hose comes off the right and the cord off the left, similar to your set up. My problem is that I get tangled up in the cord on one side and the hose is in my way on the other. Not a big deal, but I would have been happier if they were both on same side, I could work from the other.
(Message Deleted by Poster)
Chuck Lenz
Re: Barry, my thinking was ...
Barry Irby
Makes perfect sense. In my case, the crank is on the top. It would have been better for me to have the dust hose go off the other side, with the cord.
Re: Ryobi AP12 Surface Planer Dust Hood with 4" po
Michael Wilkins
With the exception of HVAC duct pipe, this looks like something factory made. Great solution for a 'chippy' problem. I used to have a Ryobi 12" planer and I know the dust collection from the factory is not very efficient
great execution!
Tom Dunlap
nicely done!
when my hand heals and i get back in the shop i'm going to follow your design.
this will be the reason to get shield gas for my wirefeed too!
Re: Ryobi AP12 Surface Planer Dust Hood with 4" po
Vincent Booth
Now that's a dust collector. Mine is always getting clogged, I'll have to see if I can fashion something like that. If you don't mind me using your design, that is.
Great job.