Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

shaker bench design question

Posts

shaker bench design question

#1

shaker bench design question

mreagan

I'm coming back after a 5 year hiatus here. two kids, new job, and two moves later in a different state, I have time to build again. on to the design issue at hand...

I am building a shaker bench, designed exactly like the one in woodworking mag from winter '09, except I dont want cut nails or any nails for that matter. So would gluing the aprons to the top, then pegging the aprons to the legs be sufficient in strength to hold the piece together? I was thinking titebond III would be sufficient in strength. I could also add the clips, normally used for attaching tabletops, to legs and the bench seat. Thanks for your thoughts and glad to be back...

Re: shaker bench design question

#2

Re: shaker bench design question

paul in AZ

I'm dubious about the strength. If showing no hardware is the goal how about screws with recessed heads covered by a dowel plug?

Re: shaker bench design question

#3

Ellis Walentine

If'n I understand your question...

Ellis Walentine

...not having a copy of that issue at my fingertips at the moment, I'd say don't ever glue a top onto an leg and apron assembly unless the top is a frame and panel itself and will not move differentially from the base. It's an invitation to some pretty bad movement/cupping problems. The z-clips are more than adequate to hold a top to an apron.

Cheers, and welcome back! We kept the light on for you. :)

Ellis