Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Band Saw speed results

Posts

Band Saw speed results

#1

Band Saw speed results

Bill Tindall

A while back someone asked how fast a band saw with a big motor could cut. I was resawing tonight and collected a bit of data for the discussion.

The victim was a 7" wide walnut plank 52" long. The saw, a 1954 20" Delta with an ancient 1 HP motor (supposedly what ever kind it is is more powerful than a modern 1 HP motor, I'm told). Blade is 3/4 x 3 tpi Starrett.

It took 30 seconds to slice a piece off the plank. This feed rate was limited not by the motor but by the tooth gullets. Any faster and the saw dust was packing the gullets. A blade with larger gullets (less tpi) would have enabled faster sawing and at some point I would have been motor limited.

I intend to buy a 1.5 tpi carbide for resawing as the steel blades get dull fairly fast.

Re: Band Saw speed results

#2

30 Seconds!

George Colonel's Workshop-Havertown PA

Good Morning Bill,

Geeze, it takes me 30 seconds to bend over and pick up a 52 inch board with my '39 model Legsnback limitation! ;)

George