Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Sanding Big panels in a Drum Sander/Performax???

Posts

Sanding Big panels in a Drum Sander/Performax???

#1

Sanding Big panels in a Drum Sander/Performax???

Barry Irby

For those of you that have a drum sander like a Performax. I have a 16/32 Performax. I needed to sand panels that were about 2' by 7' and 7/8" thick, walnut. My shop is small and the position of the Performax is awkward.

How do you do large panels? Do you use additional infeed and out feed tables? Any tricks or tips would be appreciated.

Re: Sanding Big panels in a Drum Sander/Performax???

#2

Clint Searl

Rent a multi-disk floor sander

Clint Searl

Re: Sanding Big panels in a Drum Sander/Performax???

#3

That's funny....

Barry Irby

I already suggested that to my son. We are on the same wave length.

Re: Sanding Big panels in a Drum Sander/Performax???

#4

Re: Sanding Big panels in a Drum Sander/Performax?

Mark Mandell - Gone Round In Jersey

I use 3 roller stands set outboard of the conveyor table on my 22-44. I set the middle stand a tad above to table to prevent sag in the "panel" which may result in crowning the workpiece. I've done 38x72 table tops this way with good results.