Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Router anti-slip pad dots.

Posts

Router anti-slip pad dots.

#1

Router anti-slip pad dots.

Doug Reynolds in Seattle

I have one of the usual router anti-slip pads but, it leaves little round dots on the surface after all my hard work sanding. Will these dots show through and ruin the shellac finish? How do I get rid of the little darlings?

Re: Router anti-slip pad dots.

#2

Re: Router anti-slip pad dots.

Bill Tindall

Can't answer your question but I use the mesh shelf and drawer liners/carpet pad. . The stuff is rubbery and looks like expanded metal. They are great. Because of the open structure chips and junk falls harmless through the holes so it doesn't scratch. I put work to be assembled on it, sharpening stones, things to be sanded or routed.

It sounds like something I would sand off before finish

Re: Router anti-slip pad dots.

#3

Re: Router anti-slip pad dots.

mdclor

I think they will disappear when you vacuum or tack off the piece.

HTH,

Merle

Re: Router anti-slip pad dots.

#4

Equally bad experience

Neal in San Jose

I cut up an old router pad for padding in the bottom of a drawer I store hand planes in, and it etched a pattern in the bottom of several cast iron planes. Needless to say when I discovered it, I threw the stuff away. I don't think moisture was the problem, because this is basically a desert and I've had other similar materials that didn't do anything. I think there was a reaction between whatever that pad was and the iron. Good luck getting that off without resorting to resanding the whole piece.

Re: Router anti-slip pad dots.

#5

I had trouble.....

Barry Irby

with stuff that sounds like what Bill mentioned. Some sort of cheap tan/brown shelf material. Don't know the brand or even where I bought it. My vague recollection is that it was not sold specifically for wood workers but was shelf liner or some such thing.

I use it for a sanding pad and left a piece of work laying on it for a few days and it imparted the pattern to the work. I posted here about it about two years ago and the consensus was that it would not show through the finish, and it did not. However, I don't leave things laying on it for extended periods of time any more, just to be safe. I suspect the substance that left the imprint may have outgassed as well.

Re: Router anti-slip pad dots.

#6

Re: Router anti-slip pad dots.

del schisler

sure they will show I guess you will have to sand them out Use a ROS I wouldn't use that kind of pad I sand wood on wood I use wood stop's with clamps and have no problum

Re: Router anti-slip pad dots.

#7

The why's of the problem

Bill Tindall

Probably the stuff making the spots is plasticizer from the plastic parts. Plasticizers are greasy molecules. I suspect a water based finish would not like to sit upon one of these spots. I doubt there would be any problem with a solvent based finish. But then, doesn't everyone scuff sand just before finishing? which would remove the offending spots.