Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Drum Sander Sand Paper Question?

Posts

Drum Sander Sand Paper Question?

#1

Drum Sander Sand Paper Question?

Barry Irby

I have a Performax 16/32 drum sander. Getting ready for a project. Need to restock on sandpaper. Any advice? What grits do you find most useful? (Will be sanding some wide walnut boards from rough sawn to finished thickness.) I am thinking I will buy the long rolls and cut my own strips to length. Is there any type of grit that is better than the others? Where have you found the best price?

Re: Drum Sander Sand Paper Question?

#2

Abrasive Planing

Mark Mandell - Gone Round In Jersey

Ain't what it was once cracked up to be; use the heavier grits and you'll be losing a lot of wood before you get the deep scratches out.

My workhorse grit on the 22-44Pro is 100. I then move to 120 and then 180 depending on the wood. Figured Cherry, with its sap pockets, won't take finer than 120 without gumming up and putting a burn streak down the board [RPITA to remove from both wood and belt]. I've also had issues arise with walnut that has a lot of sapwood included.

Klingspor is about the best that I've found. Go there through the WC Marketplace link.

Re: Drum Sander Sand Paper Question?

#3

Re: Abrasive Planing

Basil

I used to visit the WoodworkingShop in Charlotte N.C. regularly. I would buy Klingspor scrap rolls by the pound out of the scrap box in the 80/120 grit range. Some of the rolls were to short so I just cut the strips a little wider. My 18/36 Delta used 2" but I have cut strips 2 1/2" to 3" for it....whatever it took to make them work.

Re: Drum Sander Sand Paper Question?

#4

Re: Drum Sander Sand Paper Question?

DizD

I got a roll of the blue alumina-zirconia in 36 grit from Klingspor. For planing from rough this stuff is bulletproof. I glue up cutting boards now and never bother to scrape glue off - just flatten with the blue belt and never get a buildup on the belt. Course you have to graduate to finer belts well before the final thickness because of the scratches.

Re: Drum Sander Sand Paper Question?

#5

Rick L

Re: www.industrialabrasives.com

Rick L

www.industrialabrasives.com has the best prices and good abrasives overall. Better prices than Klingspor, Supergrit, etc, last I looked. I buy for a commercial company 80-150 grits

Re: Drum Sander Sand Paper Question?

#6

Re: www.industrialabrasives.com

Gary Smyth

If going from rough lumber, and you have one, I'd save much abrasive and plane the boards first. You can then stick with the medium/finer grits only.