Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Stripping cabinets "problem"??

Posts

Stripping cabinets "problem"??

#1

JL

Stripping cabinets "problem"??

JL

The LOML wants to strip the kitchen cabinets.

The previous homeowners painted the bottom cabinets brown and the upper cabinets off white. Underneath the paint is some decent looking red oak. We stripped part of the bottom cabinet when we installed our new dishwasher. We used Citristrip (which worked reasonably well).

The difficulty lies in the pigments that remain. Some of the brown has gotten into the grain and into the pores of the red oak. It actually looks okay. But I can see where it might "clash" with the upper cabinets when they are stripped. The upper cabinets would look "pickled" while the bottom cabinets would have some residual brown.

Any suggestions on how to get the brown out? Would a 2 part bleach work?

We had planned leaving them "natural" as the inside of the doors and drawers is "natural". Should I consider a stain to even them out?

TIA for your thoughts.

Re: Stripping cabinets "problem"??

#2

Re: Stripping cabinets "problem"??

Bob Lang

A two part bleach will act on the wood. Chlorine bleach will remove the color, if it is a pigment. If it's dye you're out of luck. Laundry bleach will likely be too weak, you can get chlorine for treating swimming pools and mix with water for a stronger solution. As always, experiment on something inconspicuous and be careful handling chemicals.

Bob Lang

Re: Stripping cabinets "problem"??

#3

Re: Stripping cabinets "problem"??

John Veerkamp

If stripping leaves too much brown or white, you may be able to put a white pore filler over the brown to bring them closer in appearance.

John

Re: Stripping cabinets "problem"??

#4

Re: Stripping cabinets "problem"??

Howard Acheson

First thing I would do is get a stripper that contains methylene chloride and re-strip the cabinets. "CitriStrip" is not a very effective stripper. What you are dealing with is finish and residue that is lodged in the deep pores of the wood. A methylene chloride stripper will due a better job at getting the finish out of the the deep pores in red oak. Use a stiff bristled plastic brush to work the stripper into the pores. I like to use a water rinsing paint stripper. A garden hose and the stiff bristled brush should get all the stripper off.

As to bleaches, there are three used by finishers.

o Chlorine Bleach--used to remove dye stain from wood. (Pigment stain is removed by the paint stripper.)

o Oxalic Acid--used to remove black water and mineral stains from wood.

o Two part A/B bleach--used to remove the natural color from wood.

Be sure an use distilled water as municipal water frequently contains minerals and metals that will discolor oak in particular.

If you still have residual color in the wood after using the better stripper, try using the chlorine bleach. Clorox will work fine as long as it is fresh. Mix one part Clorox to five parts distilled water. flood the surface and keep it wet for 15-30 minutes. Rinse it off and let it dry. Do it again if a lot of stain remains. You will not generally get it all out.