Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Minwax Poly Shades - Can you spray it?

Posts

Minwax Poly Shades - Can you spray it?

#1

Minwax Poly Shades - Can you spray it?

David Lykins - guitardude - Dallas GA

OK, I'm fairly confident that I know the answer to this but I was wondering if you could spray standard Minwax Poly Shades, and if so I'm assuming you may have to thin it? I have a regular gun and a touchup gun, both from Harbor Freight so they're nothing high tech or special.

Anyway, I was just curious.

Re: Minwax Poly Shades - Can you spray it?

#2

Clint Searl

Re: Minwax Poly Shades - Can you spray it?

Clint Searl

I only spray solvent lacquer, but I wolud thin it with naptha and spray the lightest wet coat I could manage for any vertical surfaces.

Clint

Re: Minwax Poly Shades - Can you spray it?

#3

Ellis Walentine

One thing to think about

Ellis Walentine

... well, maybe three things: First, that product is what we call stain varnish, so the depth of the color is directly proportional to the amount of finish you put on. Actually, spraying is probably easier to control than brushing in this regard. The other thing is that you've gotta use a face mask that fits well, because varnish spray is very sticky and can clog your windpipes in no time flat, not to mention glue your nose shut. And, don't lay it on too thick, as the slow drying time will result in sags on vertical surfaces. Practice makes perfect.

Ellis

Re: Minwax Poly Shades - Can you spray it?

#4

Re: One thing to think about

David Lykins - guitardude - Dallas GA

Thanks guys, I have a good spray mask as when I had my other house I had built a spray booth in my basement, it was really cool, but don't have the room here.

I just put my first coat on, I brushed it on and what a pain so spraying would be ideal especially since I totally screwed up when I priced the display units.

Thanks again.

Re: Minwax Poly Shades - Can you spray it?

#5

Yes & Maybe

Mark Mandell - Gone Round In Jersey

I've sprayed it on doors where I could keep the surface flat. You do, however, have to keep agitating it and apply light 2-pass coats to avoid overlaps. I used a wide fan and added 10% VM&P naptha to improve the drying and leveling.

For vertical surfaces (like woodwork) I prefer hand applying with a foam brush where you start at the top and work down tipping off into the previous section above to avoid the lap marks. This also prevents sags and runs.

I wouldn't use the stuff on furniture.