Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

A rust problem, Help!

Posts

A rust problem, Help!

#1

A rust problem, Help!

doug f, san clemente, ca

Sharpening a plane iron, I injudiciously spritzed the sole of my favorite Lie-Nielsen block plane with water. I didn't notice and one night in the Southern California beach climate resulted in several small rust spots. The rust came off easily with a couple swipes of 1500 grit paper, but they left a few small stains on the sole. It doesn't affect the cut at all, but it irks me and reminds me how dumb I can be.

Does anyone have a method of removing these stains? My plane and I would be very grateful.

Thanks for the help.

Doug

Re: A rust problem, Help!

#2

Re: A rust problem, Help!

Normp

You can try "rust erasers"

These are sanding blocks which are avail. in coarse to fine grits.

They don't even resemble sandpaper, more like felt blocks.

They might work for you, great for bringing a luster back to discolored metal.

I picked mine up through Lee Valley Tools.

Norman

Re: A rust problem, Help!

#3

solution

Bill Tindall

wear it off making fine furniture. And if you are like me soon you will be facing so many problems building stuff that thoughts of the spots will drift from memory.

This is a total educated guess based on the fact that ferric iron is rust colored and ferrous iron is nearly colorless and to get from ferric to ferrous requires a reducing agent. Try rubbing the spot with damp ascorbic acid (AKA fruit fresh or Vit. C tablet crushed up). If it works let us know about it.

Re: A rust problem, Help!

#4

Hot damn, Bill!  You're a genius!

doug f, san clemente, ca

A little lemon juice and bingo! The spots aren't completely gone, but they are significantly reduced. A couple more applications and they should be unnoticeable.

Many thanks for the solution.

Doug

Re: A rust problem, Help!

#5

fine line between  genius  and luck

Bill Tindall

Probably what did the trick was the combination of citric acid and what ever reducing power the preparation had. I was tempted to suggest adding citric to the ascorbic acid but was unsure if it would dull the iron finish. In any case don't leave the lemon juice in contact any longer than necessary, wash and oil or wax after you are done with the chemistry experiment.

Re: A rust problem, Help!

#6

Done and done.  Thanks again.

doug f, san clemente, ca

Re: A rust problem, Help!

#7

Re: A rust problem, Help!

Justin Szeliga

I was looking for a rust remover a few months ago & found a recipe for 10% solution of molasses in hot water. Works quite well.

Re: A rust problem, Help!

#8

Re: A rust problem, Help!

Don Evans

In future if at all possible, immediatly after wetting bare metal blow it off with air.

Keep blowing untill you are sure metal is totally dry, do this at angle to run water out of crevices, doing this at an angle to drive water off.

Don