Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Can anyone explain this "dowel"

Posts

Can anyone explain this "dowel"

#1

Can anyone explain this "dowel"

Barry Irby

I bought some treated 2 x 8 use repairing my deck. Southern yellow pine.

I was breaking them down into smaller pieces When i noticed what appears to be a hardwood dowel In the edge of one of the boards. I found it after I ripped the piece but do not remember seeing it on the exterior edge. I searched the rest of the stock, but cannot find the other half of the board with the rest of the dowel. Not sure, but it may have been completely encapsulated in the board to start with and I revealed it when I ripped pretty much down the center. I have not cut it open, but it appears the hole goes through to the other side of this piece but at that point the hole is about 3/16" but the dowel is about 3/8". How did a hardwood dowel get into the middle of a treated pine board and Why?

Re: Can anyone explain this "dowel"

#2

My Bet

Mark Mandell - Gone Round In Jersey

is that you bought the stuff at a Borg which had stock "returned" by a homeowner who put the dowel in as part of some project.

Re: Can anyone explain this "dowel"

#3

Joe Bradshaw

Re: Can anyone explain this "dowel"

Joe Bradshaw

Barry, the dowel was probably used to plug a hole that was used to get a core sample from the tree. I remember doing this in my high school FFA class.

Re: Can anyone explain this "dowel"

#4

Re: My Bet

Barry Irby

Mark I bought the lumber at a local lumber yard. A real one, not a Borg. They had the lumber in what appeared to be an undisturbed stack, but it was part of an open bundle. I bought the remaining 30 pieces of the bundle. I saw nothing abut any of it that indicated it had been handles before, but who knows?

Re: Can anyone explain this "dowel"

#5

Re: Can anyone explain this "dowel"

Barry Irby

I wondered about that too, but, you can't tell from the picture, but the dowel goes through the rings at more than a 45 degree angle. I would have thought a plug would have been taken at nearly ninety degrees to the rings. Weird.

Re: Can anyone explain this "dowel"

#6

Crosseyed Sawmill Operator?

Al Kapocius