Apprenticeship update
Nathan
The vagaries of life intervened in my apprenticeship and I had to put it on hold for three months. Last week I went back for two days. Then more work came in so it's on hold again at least until the 15th, perhaps longer.
It was great to be back, if only for two days. The guys seemed pleased to see me and immediately put me to work. They had some "paper-core" doors and jambs from the local box store (the kind that are covered with plastic film to make them look like wood). They were altering them to make them fit in non-standard spaces in a customer's basement. One of the doors had to be cut down so much that they had to move the hinges, so there were a couple 1/4" holes had to be plugged. There was no 1/4" dowel at hand. A discussion ensued over how best to plug the holes. One of the guys was advocating the use of a steel plate with toothed holes in it - for making different diameter dowels by pounding square stock through them. But Master didn't think that would work with the hard beech ("You'd have to make the stock into an octogon," he remarked so only I could hear), and anyway, he loves his lathe (he designed and made it himself during the Communist period when small factory-made machines were hard to come by). It's a beauty, by the way - simple, solid and effective. So he cut out a small piece of European beech and quickly turned it into a dowel. Master does everything very quickly. It turned out to be too narrow because I had set the calipers wrong. By the time I found that out he was gone, so I cut out a new piece of beech and turned a new dowel to the correct diameter. Man, was that fun.
The next day almost everyone was gone installing sliding glass doors at a job site, so I essentially had the whole shop to myself. The guys told me they needed to make 200 narrow strips (1/2" x 1") for some interior doors. Instead of cutting up new boards, they asked me to go through all the scrap and pull out basically everything that was not hardwood, cut the longer pieces down on the bandsaw and and then face- and edge-joint everything in preparation for ripping. There's a lot of scrap in the shop, but most of it is hardwood. In the end I found about 60 or 80 softwood boards of varying thicknesses, many of them quite narrow, so I had my work cut out for me. I found after a few passes on Master's humongous 20" industrial jointer (the cutter block is a good 6", maybe even 8", in diameter) that I could put workpieces through very quickly and still get a relatively nice surface. Doing a big run like that, though, was somewhat exhausting and I was glad when the job was done. It'll be interesting to see the finished doors - apparently, they will have these thin boards spaced closely together in lieu of panels.
Thanks for letting me share.
Nathan



