Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Kensington lock - "eye" bolt or what??

Posts

Kensington lock - "eye" bolt or what??

#1

JL

Kensington lock - "eye" bolt or what??

JL

I want to put an "eye" bolt on a "booth" table. This is to secure a laptop to the table with a Kensington lock. I figure it would be harder to lug a table off than the laptop.

I thought about an "eye" bolt - but I was wondering about other alternatives. I was also thinking about a hasp.

Any other thoughts or suggestions??

Re: Kensington lock - "eye" bolt or what??

#2

Recessed "D" ring

Ray - Middletown, IN

Like the ones used on trailer beds for tie downs. I know someone probably makes them for furniture use. They fold down out of the way when not in use.

Ray

Re: Kensington lock - "eye" bolt or what??

#3

Couple of possibilities *LINK*

Bill Houghton, Sebastopol, CA

You can get several different kinds of recessed chest hardware handles and finger pulls from Lee Valley. Just go to the WC Marketplace, click on the Lee Valley link (that way, if you buy, Ellis gets a commission), and search the hardware section for "chest hardware" and "finger pull."

You can get a variety of non-recessed pad eyes, loop eyes, etc., from boat suppliers. This last Fall, I found the company linked below quite helpful (no other affiliation except a very satisfied customer). I've shown the section for pad eyes, etc.


http://www.greenboatstuff.com/padeyeyest.html

Re: Kensington lock - "eye" bolt or what??

#4

JL

D-rings would be less expensive...

JL

For the short term, I may go for a D-ring. I like the forged flush rings at Lee Valley though - so I'll keep that thought on the back burner.