Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Stacking/Storing wood

Posts

Stacking/Storing wood

#1

Stacking/Storing wood

Joe in a Cleveland suburb

I have my little (basement) shop gutted to paint the floor.

I have always stored my wood lying flat on leveled cinder blocks off the ground. I sticker it to. I don't know why but I do.

I could gain some much need floor space if I stored the wood vertical up against the wall(s).

I know this is debated from time to time, but does it really matter? Does it matter if it's vertical or horizontal? If it matters, most of my wood is 4/4 KD rough.

Have there ever been any tests to see if one way or the other makes a difference?

Thanks in advance.

Joe

Re: Stacking/Storing wood

#2

Dale Lenz

Re: Stacking/Storing wood

Dale Lenz

Have not seen any test, but will probably depends on how vertical you store the stock. Most of my wood is flat layed over my bench room in my shop, think room in a shop. When I pull some lumber down, it's usually to much trouble or I don't have the help to put the lumber back up in the loft if I don't need it. Will lean the wood against the wall, have not notice any major problems. Might want to build a vertical lumber rack, should make leafing through boards easier.

Re: Stacking/Storing wood

#3

Re: Stacking/Storing wood

del schisler

yrs ago the some people used to hang their boards up like you would hang up some beef Put a hanger in the end and hang it up I did that a few yrs back with Lot's of walnut and it dryed very fast and no warp If it were me i would stand it up as streight against the wall and on some block's to keep moister from getting to the botton of the wood And stack so that you can get a piece when you need it Just slide it out Not much effort their

Re: Stacking/Storing wood

#4

Re: Stacking/Storing wood

Dave Paine

I have not read about any tests of one way or another.

If the wood is dry then you should be able to store vertical or horizontal. I would still keep off the floor to avoid moisture being pulled from the floor. I would also try to keep truly vertical to avoid sagging over time. I would mount eyes in the wall to allow using some type of cord/tie to prevent the board falling forward.

My "shop" is the garage. I have height constraints, so cannot store all the boards vertically. I could not even store 8 ft vertically, and some of my boards are 9 - 10 ft.

I have dedicated one wall for lumber storage. I made my own 3 level rack with 2x4 construction plus floor. I have 3 sections to the rack, each 2 studs apart so nominal 32 inch spacing. Middle level is covered in plywood so I makes the overall rack very sturdy and can store the shorter pieces.

I then store the long boards either flat or on edge, depending on board dimensions and overall stacking efficiency.

Re: Stacking/Storing wood

#5

JL

It sort of makes a difference....

JL

Horizontal surfaces accumulate junk. Vertical surfaces don't.

The lumber yard I usually go to has bins of boards - vertical of course. I stack them horizontally - I don't have a 12' or greater ceiling. If your boards are short - I see no reason not to stack them vertically.

Re: Stacking/Storing wood

#6

Re: Stacking/Storing wood

David Hay Denver

The only thing I'd be worried about when storing the wood vertically is making sure that it was supported properly. Unless you're really careful, the wood will be leaning up against the wall at a slight angle. I'd think that the boards could bow over time unless you have some supports along the middle of the boards.

David