Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Has anybody used the a router collet extension?

Posts

Has anybody used the a router collet extension?

#1

Has anybody used the a router collet extension?

Terry Alexander

I have the Hitachi 12MV mounted in my router table with a router lift. The wrenches are getting pretty beat up and are not really that "user friendly". Replacement wrenches (off-set) cost about $15 each.

I was wondering if anybody has any experience with the router collet extensions? Makes the bit change completely above the table (as opposed to using an offset wrench) and I could then use a quality, straight wrench above the table.

Appreciate any feedback.

As always...thanks in advance.

Terry Alexander in West Texas

Re: Has anybody used the a router collet extension?

#2

Tried One

Mark Mandell - Gone Round In Jersey

years ago when I first built my router table. Quit using it pretty soon as the bits didn't run as smoothly and I had more chattering in the cuts.

Maybe they've gotten better, but the farther away from your main bearing you go, the more vibration you're going to have and the more critical will be the quality and balance of the bits you use.

Also, any increase in flex on that shaft is going to translate right to your motor bearings, increasing wear, so keep an ear cocked for sound changes in the router, especially on the wind-down.

Re: Has anybody used the a router collet extension?

#3

Re: Has anybody used the a router collet extension

Neal in San Jose

Yep, I have one. Well, two actually, but that's another story. I've use them with the templates from Eagle America to make serving bowls/trays. A fast and easy "get out of jail free" project when Valentines day or something "sneaks" up on you, and they are kinda fun to do if you don't mind LOTS of hand sanding.

Anyway, I use them in a Dewalt 625, and while they always make me nervous, they have never given me any reason to. The pattern cutting bits work just fine in them, and I don't feel any extra vibration, but I keep the speed down, never try and hog stock out and I've never used one with a really big bit. One may just solve your problem.

Re: Has anybody used the a router collet extension?

#4

Re: Has anybody used the a router collet extension

Michael Wilkins

I was ready to get one several years ago, until the salesman at the tool store asked me to read the instructions that came with the extension. All kinds of language about balancing and setting and re-setting to achieve a run-out-free rotation. The instructions seemed to add a lot of complexity to what should have been an easy install. I left the device in the store, feeling it would create more problems than it would solve. Eventually got a router lift.

Just my .02 worth.