Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Delta dj20

Posts

Delta dj20

#1

Delta dj20

vance hough

I have just purchased a 20 year old Delta DJ20 jointer. Even with an Oneida dust collector the chips fly back at me when I flatten a board. I was told that the reason may be the chip deflector. I tried to go up through the dust chute but my arms are not long enough to reach it to bend it down. Has anyone experienced the same problem and how did you get to the chip deflector? I know it is not the dust collector because it works fine with the delta 15" planer that I have.

Re: Delta dj20

#2

Jesper, Denmark

Re: Delta dj20

Jesper, Denmark

It IS the chip deflector. I had the same problem some 15 years ago, so I do not remember exactly how I fixed it.

Not too helpful, I know, but at least you have confirmation that you are looking in the right place.

Re: Delta dj20

#3

Re: Delta dj20

vance hough

Thanks Jesper. I will be calling the Delta service center Monday to find out how to access the chip deflector.

Re: Delta dj20

#4

Re: Delta dj20

McKay

Over the years and currently, I have had three different dj20s. It is a pain, but just undo the bolts that hold the jointer to the base. Have a helper with the weight and fix the deflection.

Re: Delta dj20

#5

Re: Delta dj20

Alan in Little Washington (NC)

The other part of the problem is you are not getting good suction at the bottom of the cutterhead- you are sucking air from the cabinet because the chute leading from the cutterhead to the front of the cabinet doesn't have a top!!! Cut, fit and attach a piece of plywood to make a top. See photos:




Re: Delta dj20

#6

Re: Delta dj20

vance hough

McKay thank you for helping me.

Re: Delta dj20

#7

Re: Delta dj20

vance hough

Alan, thank you very much for supplying the photos. I never thought of that. Once the bed is off I will be sure to take your advice and install the plywood. Again thank you very much.

Vance

Re: Delta dj20

#8

Re: Delta dj20

vance hough

Alan, I forgot to ask how did you attach the plywood to the top of the chute?

Re: Delta dj20

#9

Re: Delta dj20

Alan in Little Washington (NC)

Vance, I didn't attach the ply to the top- the chute sides are high so I sized the ply to fit between them. I angled the ends to match the underside of the top and the front of the cabinet. I slid the top in from the rectangular chute opening at the front of the cabinet and secured it with a screw through each side just a little below where my fingers are in the one photo. I didn't need to remove the casting to do it.

Re: Delta dj20

#10

Re: Delta dj20

Alan in Little Washington (NC)

The top just butts against the bottom of the cabinet deck the other end against the inside of the cabinet front.

Re: Delta dj20

#11

Re: Delta dj20

Bartstar

Hey -nice idea to close off the top of the chute. When I upgraded my DJ 20 with a spiral cutter-head, I removed the chip deflector then. Once I removed the defector - I have never had any other issues with dust collection. But, I still like the idea of closing the top of the chute.

Regards

Bart