Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Installing a self rimming sink

Posts

Installing a self rimming sink

#1

Installing a self rimming sink

Stephen Kirk

I ran into a problem with a new sink. I have no front edge to the countertop to attach the sink clip to. I have self rimming type that drops into a hole cut in the countertop. The sink extends almost right up to the counter leaving no where to put the clips. Has anyone else ever had this problem and found a solution.

Re: Installing a self rimming sink

#2

Re: Installing a self rimming sink

Neal in San Jose

Yes, I have. What I did to secure the front edge was to fabricate some "L" brackets that I screwed upside down to the front inside of the cabinet. I was able to buy 1 1/2 or 2 inch "L" brackets at the big orange box that I cut down to fit. The top leg will probably need to be cut down to something like 1/2 inch long, and as I recall, I had to drill a new hole in the top leg of the "L" to run the securing screw thru.

Drop the sink in and locate and mark where the brackets need to be; determine the dimensions of the brackets; remove the sink and install the brackets then drop the sink back in place and secure.

Look at this as an opportunity to "exercise your vocabulary"!

Re: Installing a self rimming sink

#3

Re: Installing a self rimming sink

Stephen Kirk

Hmm, ghe sink is in place and hooked up, but this gives me an idea. A z bracket (or an angle bracket bent a second time) screwed to the underside of the front cabinet rail could extend up far enough to catch the clip.

I gotta say, a kitchen remodel can truly expand the old vocabulary. Seems like absolutely nothing worked correctly without some amount of adjustment.

Thanks for the idea!

Re: Installing a self rimming sink

#5

Concur

Bill Houghton, Sebastopol, CA

Our kitchen sink, installed on solid surface material, is held on entirely with silicone adhesive.

Re: Installing a self rimming sink

#6

Clint Searl

Or with epoxy paste

Clint Searl

Re: Installing a self rimming sink

#7

Nope, won't work

Neal in San Jose

That will definitely stick things together and waterproof them, but if anything is not quite flat or square, there's no way to draw them together. You will then be left with a bulge or ridge that will catch dirt and basically annoy you until you finally do something about it. I don't think I've ever seen a sink/counter top assembly that didn't need some "persuasion."

Re: Installing a self rimming sink

#8

Ellis Walentine

. . . unless . . .

Ellis Walentine

...you apply some kind of clamping force, which you can do with a couple go-bars and a caul or two. I've done that successfully, and will be doing it again this year when I install our new counter top.

I prefer Lexel to silicone, though, because it seems to stick better. Urethane adhesive is even better if you absolutely never intend to remove the sink for any reason.

Ellis

Re: Installing a self rimming sink

#9

Re: Nope, won't work

Brian in SLO

All of my sinks, kitchen and bath are secured with silicone to nice flat countertops.

Hopefully your countertop is flat. If not, you've got other problems to worry about.

Re: Installing a self rimming sink

#10

Re: Installing a self rimming sink

Mark Mandell - Gone Round In Jersey

Sounds like the wrong sink for the space. Can you not move the unit further back? What is the counter made of?