Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Sanding belts

Posts

Sanding belts

#1

Sanding belts

Andrew LaFave

I just took over a teaching position and inherited a bunch of rolls of sandpaper for both portable and stationary belt sanders. I am used to ordering the size that fits the sanders. I do not want all this paper to go to waste. What is the best way to cut these to size, but moreover, what do I use to glue the seam? Thanks for your help in advance

Re: Sanding belts

#2

Re: Sanding belts

Barry Irby

Since there is a seam, I am going to assume you really need to glue them. Some machines, Like drum sanders use paper that is wrapped around the drum and clipped into place at each end. No seam to glue. Those would be easy. OTOH, my understanding is that it is nearly impossible to glue seams for belt sanders, unless you are set up to do it. The tape and glue they use are not available to us mere mortals. It's a manufacturing process.

Re: Sanding belts

#3

Re: Sanding belts

Grant in Iowa

Andrew,

I believe the common method is to use the strapping tape with the nylon filaments on the back of the belts. This can be purchased in wide widths online, or you could use several narrower strips. Cut an old belt at the seam to use as a template and length reference. Maybe make a hardboard template with the angled ends to use as a jig. When cutting sandpaper, do so from the back to save your knife blade from the abrasive.

I am sure someone can refine the process a bit, but i think that is the basics. Not sure if there is a preferred brand of the strapping tape or not.

FWIW,

Grant in Iowa

Re: Sanding belts

#4

the porblem

Bill Tindall

I believe the adhesive used to join belts is something that gets cross linked after application to the belt. I very much doubt tape will work. It will initially stick the belt together but as soon as the belt gets hot during use the adhesive will soften and the bond will fail. I have seen epoxy recommended but it makes a stiff joint that thumps.