Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Blum Tandum undermount fixture

Posts

Blum Tandum undermount fixture

#1

Blum Tandum undermount fixture

David Brown

Hi,

I am doing my first project using the undermount Blum tandem slides. Real nice unit, question is the drill fixture for the orange lock pc that mount under drawers. They want $55.00 for it. I have 3 drawesr to do. Can I fudge it or do I need the $ fixture?

Thank you

Re: Blum Tandum undermount fixture

#2

Moses Yoder

Re: Blum Tandum undermount fixture

Moses Yoder

It is fairly easy to just set the front clip in the corner of the drawer box and use a small drill bit to predrill the screw holes; you don't need a jig for it.

Re: Blum Tandum undermount fixture

#3

Re: Blum Tandum undermount fixture

DizD

I used undermounts for the first time last year and mounted 11 drawers without the jig. I put the lock piece on the slide and marked one hole w/ vix bit and screwed it in. Then carefully checked the operation. If everything worked, I put in the other screws. If it needed adjustment, I reset it and used another hole.

Re: Blum Tandum undermount fixture

#4

Re: Blum Tandum undermount fixture

Jim Dillon

David,

I agree with the other posters. I have the Blum guide plus several others (hey, I rationalized a LOT of unnecessary expensive gadgets when I did my kitchen figuring I was saving so much money :D ). While the guide makes life easier, you sure don't need it. Those Blum Tandems are really, really nice and I still marvel at how nicely they slide. In my case, the first install went slowly because I didn't want to screw up. After that, it was a piece of cake. Have fun!

Jim

Re: Blum Tandum undermount fixture

#5

Dave

Thanks and more Blum questions

dave

thanks to all, now I will push my luck!

as my first Blum tandem experience, I am doing full inset doors. I have the correct hinges, and bought the 3mm height plates, as the face frame overlaps a little. Now I see I have more like 1 to 1.5 mm overlap, so I am thinking I may need the zero height plates and then a homemade 1 mm shim? or will the hinge

adjustment allow for this error?

again, thanks to all