Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Way OT: Removing inside rear view Mirror?

Posts

Way OT: Removing inside rear view Mirror?

#1

Jesper, Denmark

Way OT: Removing inside rear view Mirror?

Jesper, Denmark

I need to remove and re-locate the inside rear view mirror in the car. It is in my way and can be relocated an inch or so higher, which will be a great improvement.

The mirror is glued to the inside of the windshield.

There is lotsa information on gluing it back if it falls off, but nothing about how to remove the old one without damaging the windshield.

Anybody been there, done that?

Thanks in advance, guys and gals.

Re: Way OT: Removing inside rear view Mirror?

#2

Re: Way OT: Removing inside rear view Mirror?

Keith Newton----Little Rock, Arkansas

I'm assuming that you don't need to know about loosening the little set screw and sliding it up the dovetail.

Did you find the kind of glue to use for putting it back on. If it is a cyanoacrylate, there is a solvent which will dissolve it. You should be able to find that at your local hobby store where they sell model airplane kits.

But you should check with a windshield glass place. They probably have to take the mirrors off of every old glass when they replace with new.

Re: Way OT: Removing inside rear view Mirror?

#3

Re: Way OT: Removing inside rear view Mirror?

John Veerkamp, Western Mo

Acetone will dissolve the CA used to afix the mirrors. Remove the mirror from the base and then soak a rag in the acetone and try to keep enough solvent on the base until it loosens. Hope this helps.

John

Re: Way OT: Removing inside rear view Mirror?

#4

Re: Way OT: Removing inside rear view Mirror?

John McGaw

Every time I've had one fall off of its own accord, it has been when it was incredibly hot and sunny and the vehicle was closed up. So, given Denmark's weather, you might consider a drive to Spain this summer. ;-)

Re: Way OT: Removing inside rear view Mirror?

#5

Whack it with a hammer?

Jerry Nicholson

Re: Way OT: Removing inside rear view Mirror?

#6

Heat

Neal in San Jose

I had a windshield replaced, and mechanic put the mirror on the new windshield WAY too low. I complained, and he was able to pop it off using a heat gun and glue it back on where I wanted it in about 5 minutes.