10" Blade question?
JL
I've got a Dewalt 10" combination, a Freud 10" combination and a few other blades (Amana, Tenyru, Sears, etc.).
I'm now pretty much in "charge" (can we say herding cats?) of the set construction at the community theatre. I'm going to be slowly upgrading the equipment as the budget allows. I bought a 10" compound miter saw for the theatre last year. I want to buy a 10" table saw to replace the old Ohio Forge table saw.
The big question - what blade to put on the saw??
I won't be the only one using it. It will be used to rip lumber, rip and crosscut plywood, rip and crosscut "flats", etc. It will probably end up going through screws, staples, paint, etc.
I don't want to put a "quality" blade on the saw - but I don't really want to but a piece of junk either. We have Lowes, Home Depot, Ace Hardware, a small Sears and the local building supply places as sources for blades. I'm looking for a blade that I won't cry about when it loses a tooth - but will still deliver a reasonable cut.
TIA



