Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Cutting Board Question

Posts

Cutting Board Question

#1

Cutting Board Question

Craig in Silverdale

I'm getting ready to make a few cutting boards for family members. Small ones, with a handle on one end. I was thinking about a thin strip of Purple heart and a strip of Yellow heart on either side of that. Was also thinking about a very thin (3/64") band of Ebony on each side then Maple on the out sides with a narrow band of either Yellow or Purple Heart for accent. The question is.

1. Will the Ebony be safe to use on a cutting board?

2. Will Titebond III adhere to the density of the Ebony?

Re: Cutting Board Question

#2

Re: Cutting Board Question

Dave Paine

I have made many boards with similar series of wood, I just do not have any ebony.

If you just want a dark wood, consider Wenge, Rosewood or even plain old Black Walnut. All are very dark when an oil based finish is applied.

Although I have not used Ebony, I expect it would work with Titebond III. I have used TB III with many tight grained woods, such as maple, purpleheart, bloodwood, and so far the glue is holding up.

I am working on a board with a yellowheart strip next to purpleheart. Very attractive contrast.