Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

help on designing drum

Posts

help on designing drum

#1

ebd

help on designing drum

ebd

I'm going to build a 13" drum to bang on.

I bought the hardware but I'm lollygaging on buying the wood and getting started. For wood I'm thinking of using either wenge or zebrawood. I've calculated 2" as the top of the stave for 15 degree/12 stave segements. I'm afraid to proceed as I'm not sure I'm correct. I can make trial cuts to make sure of the exact dimensions.

The biggest problem I have is that I have no idea how deep to make the shell nor how thin to turn it. I would like to get the largest range of tone possible but keep it on the deep end.

If anyone has any suggestions they would be most welcome.

Re: help on designing drum

#2

What You're Describing

Mark Mandell - Gone Round In Jersey

Is a conga drum. Suggest you to go to a music store and take some measurements, but they are usually 3' or more high. I'd anticipate your biggest problem will be getting the swell in the mid-section that gives you the low range sound you seek. As you mentioned turning, I'd also anticipate you'll need a lathe with at least a 20" swing, a bed extension plus a fairly heavy duty steady-rest to match, and some moose of a boring bar to work that far over the rest.

Re: help on designing drum

#3

Ellis Walentine

Need dimensions

Ellis Walentine

What's 13", the height? the diameter? Twelve 2" staves are only going to give you about a 7 1/2" diameter cylinder. If you want it to be 13" in diameter, multiply that by π and divide by the number of staves you want to use. If 2" is the width of staves you want, you'd need approximately 20 staves to make that perimeter. Each stave would have an included angle of 18� so the bevel on each side would be 9�.

As far as thickness, the djembes I've seen (including one we own) is pretty thick and not at all uniform. Maxwell Kofi Donkor, a great drummer and drum maker from New York used to carve his djembes. No lathes for him. They sounded great. I don't know the physics of the tensioning system for the drum head, but I believe you need a rather sturdy construction to hold up to the amount of tension you'll be putting on the finished drum assembly.

I'll bet there is a huge wealth of drum construction information to be found elsewhere on the web, as in dedicated drum sites.

Ellis Walentine, Host

Re: help on designing drum

#4

B4 you start with that expensive wood

Forrest Addy

You are making a musical instrument; an item fraught with mystery and tradition, with few scientific references that if consulted will you to a satisfactry result.

B4 you start with that expensive wood, make a few mock-ups and test assemblies to develop skill, prove concept and method, and optimize the drum's configuration.

The last rhing you want to do is use up $300 of expenive tropical wood making you very first drum that goes "thub!" when you smite it with a lusty blow.

Make your first couple of drums out of construction lumber, then a couple of low cast hardwood. When you arrive at a design that pleases your eye and ear only THEN do you commit to bacote or zebrawood.

Re: help on designing drum

#5

Re: help on designing drum *LINK*

Phil Joines

Try asking your questions at the Music Instrument Makers Forum. There are a bunch of knowledgeable people there.


MIMF