Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Replacing just a mortise bit, not the chisel?

Posts

Replacing just a mortise bit, not the chisel?

#1

Replacing just a mortise bit, not the chisel?

Stephen Kirk

I just snapped the bit in my 1/4" mortise chisel. I hit the web to find a new bit, but apparently I have to buy the chisel along with the bit. Is

this just the way it is, or can the bit be replaced?

Re: Replacing just a mortise bit, not the chisel?

#2

Re: Replacing just a mortise bit, not the chisel?

Neal in San Jose

My experience with hollow chisels is that they vary wildly from brand to brand. Even the outside dimensions are often way off. I had a 1/2 nominal that measured almost 9/16. If you know what brand yours is, you might get lucky, but I've never seen replacement augers. They are pretty cheap, so you'd probably be better off just buying a new set. Then put a handle on the old one and make a square chisel for squaring up the ends of routed dados and hinge mortises.

Re: Replacing just a mortise bit, not the chisel?

#3

Re: Replacing just a mortise bit, not the chisel?

mike American Sycamore

I jumped on line and found several companies were you can buy the bits seperate. Fisch, Delta, Fuller, CMt etc

Re: Replacing just a mortise bit, not the chisel?

#4

Re: Replacing just a mortise bit, not the chisel?

Barry Irby

I don't know about the replacement bit, but have you figured out why you broke the bit? Examine your set up and technique so it doesn't happen regularly.

Re: Replacing just a mortise bit, not the chisel?

#5

Re: Replacing just a mortise bit, not the chisel?

Stephen Kirk

Guess I'll run by Woodcraft and grab a new bit/chisel. Gotta finish the job. I'll bring my chisel along just in case they sell the bits separately.

Re: Replacing just a mortise bit, not the chisel?

#6

Re: Replacing just a mortise bit, not the chisel?

Stephen Kirk

Not sure what broke the bit. It's a couple of years old, I've cut a bunch of mortises with it, so maybe it just wore it. It was the stock chisel/bit, which maybe isn't made the strongest. The chisel was set square and was cutting well. I work in a lot of oak and walnut, so maybe I just wore it out.