Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Wood Screws

Posts

Wood Screws

#1

Wood Screws

iew

I am trying to stay as original as possible on my late Model T Ford 22'Touring car. I was replacing wood in the back seat are and needed slotted head screws to stay original. No problem, I'll just head up to the Big Box and get them. Think again, slotted head screws are extinct. After a few hardware stores I found one that had some bins in a storage area with a few slotted screws. I hate slotted screws to begin with, they look like crap after I install them. Your screwdriver head has to be the exact size to keep from boogering up the head and besides that I can't use a drill. Personally, Mr. Ford I just don't understand why you did not use Robertson head screws in the first place, oh I see, it was a cruelty joke on us. Model T's is one of my other hobbies.

Re: Wood Screws

#2

Re: Wood Screws

David Yoho

I'm not a big fan of slotted head brass screws either. However, in the reproduction and restoration work I often do I believe they are necessary to be accurate for the period. I've found Lee Valley and Horton Brasses to be good sources for quality screws and I keep plenty of the various sizes in my inventory.

Recently I was restoring an exterior door that dated back a hundred years. I was fixing a repair someone else did at some point that required using some 6-32 1/2" brass oval head slotted screws. I was in Lowe's so I had a look. To my surprise they actually had the darned things!!

David

Re: Wood Screws

#3

Re: Wood Screws

iew

These screws have to be steel. Thanks David.

Re: Wood Screws

#4

Re: Wood Screws *LINK*

Ken Garlock, Collin County Texas

Once again, McMaster & Carr come through :) IF they don't have it, you probably didn't need it. :D


Wood screws

Re: Wood Screws

#5

Re: Wood Screws

FredD

To take the pain out of installing slotted screws, get a driver with a sleeve made specially for those screws, Makita makes a good one.

FredD

Re: Wood Screws

#6

What size, I have oodlins of them

Bill Tindall

What size do you need? I have many boxes that I will sell for a pittance. I presume you need steel. If you need Brass, then WhiteChapel has the best slot head brass screws. The aris is crisp on them, unlike all others I have tried.

Re: Wood Screws

#7

Curiosity

Bill Houghton, Sebastopol, CA

Will a drill not fit the space? There are various right-angle attachments, etc., that may help. If the problem is side clearance - the screws go right up against a "wall" - then a push drill is your friend.

If you really can't use a drill, you might use a variation of the trick used for brass screws. With brass screws, it's common practice to "tap" the hole with the same size of steel screw. With your desire for slotted (presumably steel) screws, you might find a Phillips or Robertson headed screw of the same size (or, if you could find one, but they're rare in wood screw pitches, a hex head screw), and make your holes with that, then remove it and install the slotted screw.

Sheet metal screws have a different thread, but might also work for either the tapping or the permanent screw; and they're tougher steel, so the slots might hold up to driving.