Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Butterflies?

Posts

Butterflies?

#1

Butterflies?

Mark Mandell - Gone Round In Jersey

I have some squirrely walnut with some big end-checks that I want to use, Nakashima-style, as-is with butterflies. Having never done them this-a-way, my question is, do I make the butterfly first and then cut the notches to fit, or is it easier to fit the "fly" to the notch?

Second question: Assuming I'll be thicknessing with a drum sander, would you do the 'flies first or after?

[Chicken jokes are prohibited]

Re: Butterflies?

#2

Got butterflies?

Bill Houghton, Sebastopol, CA

I haven't done it, but the descriptions I've seen have done the butterflies then used them to mark the cut.

Re: Butterflies?

#3

Ellis Walentine

Make the butterfly first

Ellis Walentine

Then outline it accurately on the slab with an X-acto knife or carbide engraver and rout to a depth that is just slightly less than the thickness of the inlay. Glue it in and plane it flush when the glue dries.

Ellis

Re: Butterflies?

#4

Thickness?

Mark Mandell - Gone Round In Jersey

Since I've got a couple of splits that are an inch or so, I was thinking to make them the full thickness of the slab. Any difference in that instance?

Re: Butterflies?

#5

Re: Thickness?

Keith Newton----Little Rock, Arkansas

Mark, The few times that I have done this, I did as Ellis said, cutting the butterfly first, then using hot-glue to hold it in place while I scribed around it.

I think it is better to not go all the way through. Usually you are fairly close to the end, which would make it easy for the short grain to just split off if there is any MC change.

If it is supported by some wood continuing on through under the butterfly, this helps reduce that potential.

Re: Butterflies?

#6

Gotcha, Thanks! 

Mark Mandell - Gone Round In Jersey