Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

holes in Formica

Posts

holes in Formica

#1

holes in Formica

Gary Smyth

I'm suffering a mind freeze. I need thirty six grid spaced 1/4" holes in a plastic laminate covered board. The holes must be clean on top with no tear out. What do I use to not ruin this. Drill press is available. I remember doing this with some little trick some years ago (tape first? , "waste" board on top?) but I can't remember or find the information. A Forstner will dull after only four or five holes. A plunge routed hole would be a pain. Suggestions please.

Re: holes in Formica

#2

Re: holes in Formica

Andy Wright - Allen, TX

Not knowing your entire setup, its hard to say exactly how to do what you are looking for, but here are two suggestions:

1) clamp your board with a piece of scrap on top, and drill it with the drill press nI dont think you will need any tape, but it wont hurt anything. Another suggestion is that you can use a piece of pegboard as a guide to get your holes on an even grid

2) make a jig so that you can use a plunge router with a collar. I have one set up for shelf pins that has a series of 5/8' holes in mdf, and then I put on a collar with a 5/8" OD and use a 1/4" bit with. Once you line up the jig and clamp it down, it goes quick

Re: holes in Formica

#3

clever

Bill Tindall

I'll use your tips in another application....thanks