Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Lining Vice Jaw Faces

Posts

Lining Vice Jaw Faces

#1

Doug in Seattle

Lining Vice Jaw Faces

Doug in Seattle

When lining vice jaw faces with leather or similar material, is it best to line both faces and what do you recommend to hold the leather in place? I tried carpet tape but it does not seem to hold well. Will 3M spray adhesive work or, rubber cement? Of course, I want to be able to replace the leather if need be farily easily. I am lining because I use fairly thin stock for drawer sides and, they always seem to move at the worse time.

Re: Lining Vice Jaw Faces

#2

Re: Lining Vice Jaw Faces

Hank Knight

I lined both faces with leather and glued it on with contact cement, which may present a problem if I need to remove the leather. My vise faces are removable, so I figure when the time comes, I'll just replace the whole face, wood and all.

Re: Lining Vice Jaw Faces

#3

Re: Lining Vice Jaw Faces

Mark Mandell - Gone Round In Jersey

Glue your leather to a couple of pieces of plywood that will ride on the vice screw/guides but protrude 1/4" above the jaws ad are 14" longer than your jaws are wide. Tie them together with a bit of string so you don't loose just one.

Done

ps: Plumber's Alternative - get two pieces of sheet lead and bend them over the jaws.

Re: Lining Vice Jaw Faces

#4

Re: Lining Vice Jaw Faces

Tom Pilsbury (Chicago)

I cut out a couple pieces from a mousepad and fastened them w/carpet tape. Works fine.

Re: Lining Vice Jaw Faces

#5

Leather is Way Sexier 

Mark Mandell - Gone Round In Jersey

Re: Lining Vice Jaw Faces

#6

Re: Leather is Way Sexier

Normp

Funny, I just finished doing this to the vises on my benches.

I use 1/8 in. thick leather ( rough one side) and glued the pieces on with yellow glue. The yellow glue gave me some wiggle room to align the linings with the wood jaw faces. I used a thin ply template to cut the pieces beforehand and did the final little bit of trimming with a block plane. I find I don't have to tighten the vise as much now for a good grip.

I also didn't know how well a block plane works on the edges of stiff leather :)

Norman

Re: Lining Vice Jaw Faces

#7

Re: Lining Vice Jaw Faces

Dick Coers

I used 1/4" Luan, used Tite Bond to glue leather to one side, contact cemented vinyl magnet material to the other side. I can then easily remove it if I want to.

Re: Lining Vice Jaw Faces

#8

I use removable faces

Andy Wright - Allen, TX

I have a few sets of liners for my vise, and they are held to the face of my steel vise using rare earth magnets instead of screws. One set is hard maple (with knicks and dings for "rough" work), another set is also hard maple (nice and clean that I use when I am woried about leaving marks on my work piece), and the other set is 1/2" plywood with adhesive backed felt (for delicate work). For the leather faces you are looking for, you could simply glue the leather to a piece of wood and clamp it in the vise to cure. I also sometimes take the faces out completely and use the steel faces of the vise if I am putting something "non-wood" into the vise.

I have found that using the magnets to hold them in place is more convenient than attaching the vise faces with screws. An added benefit is that I can get away with 1/2" faces which gives me slightly more capacity in my bench vise. I have never had a problem with the magnets slipping