Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Decorative fence material?

Posts

Decorative fence material?

#1

JL

Decorative fence material?

JL

I have been asked to build a couple of fence "panels" and uprights/posts.

There will be a larger upright/post that will be about 6" or so in width connected to a smaller post that will be 3.5" in width. The two uprights will be connected with a decorative panel. The height of the larger upright will be 5' or so and the height of the smaller will be 3' or so.

I was planning on making the larger upright "hollow" and setting it over a pressure treated post that I will sink into the ground. This will secure it and provide anchorage.

What would be a suitable material for the uprights and panels? They will be painted with suitable exterior paint. The client wants some stopped flutes on the larger uprights.

I would prefer not to "break the bank" with material costs. I can get 1 x 8 cedar easily at a reasonable cost. I can also get hardwood for reasonable prices - but just "plain" hardwood (oak, poplar, etc.). I can also get whatever is available at Home Depot or Lowes.

TIA

Re: Decorative fence material?

#2

Re: Decorative fence material?

Barry Irby

Cedar would work well, if its not too knotty. The knots may show though the paint and will also be problematic for the flutes. I suspect the knots will chip out if you try to run the flutes through them and may fall out later. Careful preparation will help reduce the painting problems.

White oak would also work well the weather, but will be heavier than the cedar. Black locust is very durable in the weather if you can find it, but is also heavier than the cedar. I suppose since it is painted you could mix them up and use the oak or locust for the fluted arts and cedar for the rest.

Re: Decorative fence material?

#3

fluted posts

Andy Wright - Allen, TX

one issue you will have with 6"x6" posts is that they tend to split. If you want for the flutes to remain "clean" (rather than the rustic look), I would consider using a 4x4 core for the post and then wrap it with 3/4" fluted material. Since it is a fence, the 4x4s will give you plenty of structural support

Re: Decorative fence material?

#4

JL

Re: fluted posts

JL

I am going to do this. I was going to get either cedar 1 x 8s or other 1 x 8s.

Re: Decorative fence material?

#5

JL

Re: Decorative fence material?

JL

Thanks.

I guess I will pick and choose. The HH lumberyard is a nice "rural" lumberyard and they are used to "browsers".